Getting an 8 RO Membrane (What to Look for When Buying)

I wanted to get myself an RO membrane. I’ve been reading up on them a lot lately, trying to figure out what’s what. These things are pretty important, right? It’s like the heart of the whole RO system.

So, I started digging into the different types. There are all sorts, it seems, each with its own pros and cons. I was looking at the specs, trying to make sense of it all. You know, things like the size, how much water they can filter, and what they’re made of. I’m not gonna lie; it got a bit overwhelming.

Figuring Out the Size

One of the first things I noticed was the size difference. The 8040 membranes are way bigger than the 4040 ones. Like, double the diameter. That means more surface area, right? So, logically, they should be able to filter more water. I spent a good chunk of time just comparing sizes and trying to visualize how much space they’d take up.

Checking the Quality

Then there was the whole quality thing. I learned that the performance of these membranes isn’t just about how much water they push through. It’s also about how well they clean the water. I found out that they measure this by checking the water’s electrical conductivity. Apparently, pure water doesn’t conduct electricity well. So, the less conductive the water is after it goes through the membrane, the better the membrane is doing its job. I started looking for membranes that did a good job removing all sorts of gunk, like chlorine, lead, and other nasty stuff.

Making the Decision

After a few days of going back and forth, reading reviews, and comparing specs, I finally made my choice. I opted for an 8040 membrane. It seemed like the best balance of size and performance for what I needed. Plus, it promised to remove a whole bunch of contaminants that I was worried about. I placed the order and waited impatiently for it to arrive.

Setting It Up

When it finally showed up, I was like a kid on Christmas morning. I got everything set up, following the instructions to a T. It was a bit of a hassle, but I managed to get it all connected without too much trouble. I turned on the water and held my breath, hoping I hadn’t messed anything up.

Testing the Waters

To my relief, everything worked perfectly. I tested the water, and it was amazing. It tasted so much better than before. I even did a little test with a conductivity meter I borrowed from a friend, and the results were impressive. The membrane was doing its job, and I was pretty proud of myself for figuring it all out.

So, that’s my story of getting an 8040 RO membrane. It was a bit of a journey, but I learned a lot along the way. And now, I’ve got clean, great-tasting water, which is pretty awesome if you ask me.