Need Clean Water? Find Out the Best RO Membrane Brand Today!

Let me tell you about my little adventure into the world of RO membranes. So, I’ve got this water filtration system at home, right? And the heart of it is this RO membrane thingy. I started noticing the water wasn’t tasting as crisp as it used to, and the flow was getting a bit sluggish. Time for a change, I figured.

First off, I hit the internet, trying to figure out what’s what in the RO membrane world. It’s a jungle out there, I’m telling you! There are a lot of brands that all made in china. They said “The selection of RO membrane series should be based on the end user’s requirements for desalination rate, operating pressure, fouling rate, cleaning frequency, and effluent water quality. Brackish water membrane is mainly used for well water, river water, lake water.” But it is too hard for me, I just want to drink some pure water, that’s it! Then I saw someone mentioned “Dow Filmtec SW30-2540 Membrane”, this got me digging deeper. Turns out, this membrane is a real workhorse.

Getting My Hands Dirty

So, I ordered one of these Dow Filmtec membranes. When it arrived, I cleared out my schedule for a little DIY project. Now, I’m no plumber, but replacing an RO membrane isn’t rocket science. I turned off the water supply, disconnected the old membrane, and slotted the new one in. It was a bit of a tight fit, but I managed. I also saw someone said “Tubular membranes are best for streams with high TSS or TDS or high oil content since they are easy to clean and resist clogging. Their main disadvantage is moderately low surface area for their size, compared to other membrane configurations.” But this seems doesn’t fit my situation.

• Turn off water supply
• Disconnect old membrane
• Install new membrane
• Turn water back on

The Moment of Truth

After getting everything hooked back up, I turned the water back on and let it run for a while, just like the instructions said. The first few liters were a bit cloudy, but that’s normal. Then, I took my first sip of water filtered by the new membrane. Man, what a difference! It was like drinking pure mountain spring water. Crisp, clean, and no weird aftertaste. There was a website said:”RO technology can remove 95% to 99% of total dissolved solids (TDS) from source water, as well as chlorine, fluoride and other impurities.” Sounds great!

Keeping It Clean

Now, I learned that keeping your RO membrane clean is key to its longevity. I found some products that are supposed to help with that. “AMI Antiscalant for Reverse Osmosis Systems. Flocon 135 Antiscalant for RO Systems. Flocon 260 Premium Antiscalant & Antifoulant for RO Systems.” I haven’t used them yet, but I’m planning to give them a shot. I’m all about that preventative maintenance, you know?

Final Thoughts

So, there you have it. My little journey into the world of RO membranes. If you’re thinking about replacing yours, I’d definitely recommend checking out the Dow Filmtec ones. They’re a bit of an investment, but totally worth it in my book. And remember, a little DIY spirit goes a long way. Stay hydrated, folks!