Best Big Blue Filter Housing Brackets: Check Out Our Reviews and Buying Tips For Your System

Okay, so I’ve been messing around with these Big Blue filter housings lately, specifically the brackets. You know, those things you use to mount the whole water filter setup? Let me tell you, it’s been a bit of a journey.

First off, I grabbed a couple of these Big Blue filter housings, the 10-inch and 20-inch versions. They’re pretty hefty, designed to hold these big filter cartridges that clean up the water supply. I figure they’re perfect for my home, given the questionable water quality around here.

Then came the brackets. I ordered some online – you know the usual industrial types, nothing special. When they arrived, I unpacked everything and laid it all out. That’s when I realized that mounting these things wasn’t going to be as straightforward as I thought. Also, before installing, I cleaned all the parts.

The filter housings have these grooves at the top where the O-ring sits. So, I cleaned those out, lubricated them with some silicone grease, and carefully placed the O-rings back in. Then, I screwed the filter housings back onto the system head, just hand-tightening them.

Now, the instructions said these housings can handle up to 90 psi of pressure, but they also warned that if your water pressure might go over 80 psi, you need to be careful. I hooked up my pressure gauge just to be safe, and thankfully, my pressure was well within the safe range.

Finding the Right Spot

• Surveyed the basement for a good location.
• Considered proximity to the main water line.
• Made sure the area was accessible for future filter changes.

Next, I started figuring out where to actually mount these things. My basement is a bit of a mess, so I spent a good chunk of time just clearing out a space. I needed to find a spot that was close enough to the main water line but also accessible for when I needed to change the filters. These brackets require solid support, you know?

After some trial and error, and a few choice words, I finally got the brackets mounted. It took some drilling, a few screws, and a level to make sure everything was straight. The whole process was kind of a pain, but I managed to get it done.

Finally, I connected the filter housings to the brackets, double-checked all the connections, and slowly turned the water back on. I was holding my breath, I ain’t gonna lie. But hey, no leaks! Success!

So, yeah, that’s my story with these Big Blue filter housing brackets. It wasn’t the easiest DIY project I’ve ever done, but it’s definitely satisfying to have it all set up and working. Now I can rest a little easier knowing my home’s water is getting an extra layer of filtering. These filters are supposed to remove all sorts of junk from the water, so hopefully, it’ll make a noticeable difference.