How Does the Watts Big Blue Water Filter Stack Up? (Easy Tips for Choosing the Right Water Filter)

Okay, here is my sharing about the “watts big blue water filter” installation:

A few days ago, I decided to get a whole house water filter because the water quality in my area is not that great. After doing some research online, I went with the Watts Big Blue. It seemed like a solid choice and not too complicated to install, plus the price was reasonable.

So, I ordered the filter online, and it arrived in a couple of days. The package came with the filter housing, a mounting bracket, a wrench, and a pressure relief button. I already had most of the other necessary tools like a pipe cutter, some fittings, and Teflon tape, so I was good to go.

The first thing I did was turn off the main water supply to the house. Safety first, right? Then, I picked a spot on the main water line to install the filter, making sure there was enough space around it to change the filter easily when needed. I measured everything out and marked where I needed to cut the pipe.

Using the pipe cutter, I carefully cut the main line and installed the necessary fittings to connect the filter housing. I used a bunch of Teflon tape on the threads to make sure there were no leaks. Then, I mounted the filter housing to the wall with the bracket, ensuring it was securely in place. It felt pretty solid, which was good.

• Turn off the main water supply.
• Choose a suitable location for the filter.
• Measure and mark the pipe for cutting.
• Cut the pipe and install fittings with Teflon tape.
• Mount the filter housing securely.

Next, I connected the water line to the filter housing, making sure everything was tight and secure. It took some elbow grease, but I managed to get it all connected without too much trouble. After that, I slowly turned the main water supply back on and checked for any leaks. At first, I saw a few drips, so I tightened the fittings a bit more, and that did the trick. No more leaks!

Finally, I pressed the pressure relief button on the filter housing to release any trapped air and let the water run for a few minutes to flush out the system. The water looked much clearer, and it definitely tasted better. I was pretty stoked about that!

Overall, the installation was pretty straightforward. It took me a few hours, but I was taking my time and making sure everything was done right. Now, we have clean, filtered water throughout the whole house, which is awesome. If you’re thinking about installing a whole house water filter, it’s totally doable, even if you’re not a plumbing expert. Just follow the instructions, take your time, and you’ll be all set!