Chemical Feed Tank: What Is It and How Does It Work?

Okay, here’s my blog post about my experience with a chemical feed tank:

So, I had this project where I needed to set up a chemical feed system. A big part of that was getting the right tank. It sound simple, it’s just a tank, right? It’s more than that.

Picking the Right Tank

First, I spent some time figuring out what kind of chemical I was going to be storing. Turns out, that matters a lot. Some chemicals will eat right through certain materials. I looked at compatibility charts, read some boring safety data sheets, and even called a couple of manufacturers to double-check. Seriously, you don’t want a tank dissolving on you.

I decided to build the new unit,I need to do a full material take off so I ordered all the parts.

Getting It All Set Up

Next, I had to figure out where to put the darn thing. I needed a spot that was level, accessible for maintenance, and, most importantly, had secondary containment in case of a spill. I ended up building a small concrete pad with a berm around it – better safe than sorry, I always say!

• Level Surface
• Easy to get at
• Spill protection

Putting It All Together

With the location sorted, I got to work on the actual installation.I’m good with tools and stuff, and followed the manufacturer’s instructions like it was the Bible. I made sure all the fittings were tight, used the right kind of sealant, and even pressure-tested the whole setup before putting any chemicals in it.

The tank arrived,I started to assemble it with the parts.

Testing and Tweaking

Once everything was connected, I did a few test runs with just water. I wanted to make sure the pump was working correctly, the levels were reading right, and there were no leaks. I found a couple of minor issues – a loose fitting here, a slightly misaligned pipe there – and fixed them before adding the actual chemical.

It’s Alive!

Finally, I filled the tank with the chemical and started the system. It was a bit nerve-wracking at first, but everything worked as it should! I monitored it closely for the first few days, checking for any leaks or unexpected behavior. It’s been running smoothly ever since.

My takeaway? Don’t underestimate the importance of a good chemical feed tank setup. It’s not just about the tank itself, but also about the planning, the installation, and the careful testing. Take your time, do it right, and you’ll avoid a lot of headaches down the * is good to see the new chemical feed tank running!