Big Blue 3 Stage Filter: Is it really worth it for your home water supply?

Okay, so, I’ve been dealing with our water quality for a while now, and I finally decided to install a 3-stage big blue filter system. I heard a lot about these, especially how they can handle a bunch of different water issues, so I thought, “Why not give it a shot?”

First, I looked around, talked to some folks who know about water filters, and did a little reading online. It turns out, these big blue filters are pretty popular for homes. They’re big, sturdy, and seem like they can really clean up the water. I chose a 3-stage system because I figured it would cover most of the stuff I wanted to get rid of, like sediment, chlorine, and some other junk.

I ordered the system online, and when it arrived, I got to work. I gathered all the parts, which included three big filter housings, a mounting bracket, and some fittings. I started by shutting off the main water supply. Safety first, right?

Next, I figured out where to install it. I chose a spot in the basement where the main water line comes in. I mounted the bracket on the wall, making sure it was secure. Then, I connected the filter housings to the bracket, one by one. It was a bit tricky to get them all lined up, but I managed.

After that, I connected the water line to the first filter housing, which is usually the sediment filter. This one catches all the big particles, like dirt and rust. Then, I connected the output of the first housing to the input of the second one. This second stage often has a carbon filter, which takes care of chlorine, bad tastes, and odors. Finally, I connected the second housing to the third, which can have another type of filter depending on your needs. In my case, I chose one that targets specific chemicals.

With all the housings connected, I hooked up the output of the third housing to the main water line that goes to the house. I made sure all the connections were tight and used some thread seal tape to prevent leaks.

Once everything was set up, I slowly turned the water back on and checked for leaks. I found a couple of small drips, so I tightened those fittings a bit more. Then, I let the water run through the system for a few minutes to flush out any air and loose particles.

The Results

I have to say, I noticed a difference right away. The water tasted better, and the chlorine smell was gone. It’s great knowing that we’re drinking cleaner water now. Plus, I think it’ll be better for our appliances, too.

Setting up a 3-stage big blue filter system wasn’t too hard, and it was definitely worth the effort. If you’re thinking about improving your water quality, I’d say it’s a good project to consider. Just make sure to plan it out, take your time, and double-check everything as you go. Happy filtering!

• Sediment Filter: Gets rid of the big stuff like dirt and rust.
• Carbon Filter: Tackles chlorine, bad tastes, and odors.
• Specialty Filter: I picked one to handle certain chemicals.

So, yeah, that’s my story on installing the 3-stage big blue filter. Pretty happy with how it turned out, and I hope this helps anyone thinking about doing the same. It feels good to tackle a project like this and see real results!