One stop supplier of water treatment parts&accessories
Considering a big blue sediment filter 5 micron? Find out if its a good fit for you.
Okay, so I decided it was time to deal with the water filter situation at my place. I’ve been noticing some sediment in the water lately, and it’s been bugging me. After doing a bit of digging around, I figured a big blue sediment filter, the 5-micron kind, was the way to go.
First off, I went online to find a filter. Turns out, any pleated or dual gradient melt blown sediment filter that’s 4.5 x 20 inches will work. I found a bunch of options, but the pleated ones are a little more expensive. Since I was on a budget, I chose the melt blown filter.
I ordered a 10-pack of these AMI sediment filters. They’re supposed to remove dirt, sand, rust, and other junk from the water. Plus, they come in different sizes, which is handy. The one I got was a 20-inch big blue one.
When the filters arrived, I got to work. I started by shutting off the main water supply – didn’t want any surprises there. Then, I located the filter housing, which was pretty easy to spot. I used a wrench to loosen it up and carefully removed the old filter. It was definitely time for a change, that thing looked nasty!
- Turn Off Water: Shut off the main water supply.
- Remove Old Filter: Unscrew the filter housing and take out the old filter.
- Insert New Filter: Put the new 5-micron filter into the housing.
- Tighten Housing: Screw the housing back on, making sure it’s snug.
- Turn Water On: Slowly turn the water back on and check for leaks.
- Flush the System: Run the water for a few minutes to clear out any air or loose sediment.
Installation Steps:
Putting the new filter in was a breeze. I just popped it into the housing, making sure it was seated properly. Then, I tightened the housing back up, turned the water back on, and checked for any leaks. Everything looked good, so I ran the water for a few minutes to flush out any air or loose bits.
This 5-micron filter is supposed to catch particles as small as 0.0002 inches – that’s way smaller than a human hair! I learned that these filters have graded pores, which means they can hold a lot more dirt without getting clogged up too quickly. That’s a win in my book.
After a few days, I can already tell the difference. The water looks clearer, and I feel better knowing that all that sediment isn’t going into our glasses. It was a pretty simple DIY project, and I’m glad I finally got around to it. If you’re dealing with sediment in your water, a big blue sediment filter is definitely worth looking into!
