ro filter membrane: Tips for Making it last longer and saving money.

Alright, let’s talk about my little adventure with my RO filter membrane. I’m no expert, but I like to keep things running smoothly around the house, you know? So, I figured I’d share my experience with changing the RO membrane – hopefully, it helps someone out there.

I noticed the water from my RO system wasn’t tasting as crisp as it used to. Plus, it seemed like it was taking forever to fill up the tank. That’s when I thought, “Maybe it’s time to look at the membrane.” I mean, I had been using it for about 4 years now.

First things first, I turned off the water supply to the system. Safety first, right? Then, I grabbed my tools – mostly just a wrench to open up the membrane housing. It’s usually this long, cylindrical container, easy to spot.

Getting the old membrane out was a bit of a struggle. It was stuck in there pretty good. I used some pliers and gently wiggled it out. It’s important not to be too rough, you don’t want to damage anything.

Before putting in the new membrane, I took a look at the housing. It had some gunk built up, so I gave it a good cleaning. I just used some water and a soft brush – nothing fancy. I think keeping this clean helps a lot in the long run.

• Inspect the new membrane: Made sure it looked okay, no weird stuff.
• Slide it in: I put the new membrane into the housing. It slid in pretty easily, which was a relief.
• Close it up: Screwed the cap back on the housing. Tight, but not too tight.

After that, I turned the water supply back on. I let the system run for a while, flushing out any air and stuff from the new membrane. It took a bit, but I wanted to make sure everything was set up right.

I also made it a point to check the pressure and the flow rate. They were a bit off at first, but I adjusted them. It’s all about finding that sweet spot, you know?

And that’s pretty much it! The water tasted great after that, and the system was filling up the tank much faster. It’s amazing what a new membrane can do.

Oh, and one more thing – I read somewhere that you should do some in-line cleaning of the membrane every now and then. It’s supposed to help it last longer. I haven’t done that yet, but it’s on my to-do list.

So yeah, that’s my story about changing the RO filter membrane. It wasn’t too hard, just took a bit of time and patience. If you’re thinking about doing it yourself, I’d say go for it. Just take it slow and steady.